The Yorkshire YP63 integral solder ring (ISR) 22mm x 3/4" bent tap connector is made of copper. This impermeable fitting provides protection against water supply contaminants and resists corrosion for reliable use in plumbing systems with properly installed systems expected to outlast the buildings in which they are installed. Suitable for use in a wide range of applications, this fitting incorporates an integral solder ring and has been designed for jointing copper tubes to BS EN 1057 (R220, R250 and R290). A solder joint is created through the principal of capillary action, when the fitting and tube is assembled and heated to the appropriate temperature, solder becomes molten and is drawn into the gap between tube and fitting for a durably reliable joint.

Pegler Yorkshire bent tap connector 22mm x 3/4"

Bent tap connector. copper x BSP hexagonal union nut. Spigot and washer joint.  Endex Endfeed capillary fittings in sizes from 8mm to 159mm.   When heat is applied  to the reel of solder, it fills in the gap between the tube and the fitting using a capillary action  creating a reliable joint.  Suitable for use on hot and cold water services for potable water, in small bore and mini bore central heating systems, and in low pressure steam heating and pressurised unvented heating systems and in chilled water applications.   Also suitable for sanitation services, compressed air lines, gas distribution systems and engineering pipeline services that convey liquids, oils, air and gases at temperatures up to 110°C.   Kite mark and WRAS Approved

Pegler Endex bent tap connector 22mm x 3/4"

Tectite is a world class push fit system incorporating pipe fittings, valves and controls delivering cost savings as a result of its speed of installation and a combination of push fit jointed technology across a broad range of materials - copper, carbon, stainless steel, PEX. The ultimate performer.

Pegler VSH Tectite bent tap connector 22mm x 3/4"

Conex Delcop bent tap connector 22mm x 3/4"

This Kuterlite K927X 22mm x 3/4" bent swivel tap connector is made of brass and has a copper x union nut connection. The Kuterlite K900/K900-Pro range of non-manipulative (Type A) DZR compression fittings is suitable for jointing plain and chrome-plated copper tube to BS EN 1057, up to 28mm with Tectite PE-X/PE-X pipe to BS 7291 part 3, PB pipe to BS 7291 part 2, XPress carbon system tube/carbon steel tube to EN10305-2 and Tectite 316 system tube or stainless steel to EN 10312. This range is suitable for closed circuit central heating systems, above ground hot and cold water services and compressed air lines and can be used with other fluids and low pressure gas services.

Pegler Kuterlite bent swivel tap connector 22mm x 3/4"

Looking for 22 mm bent tap connector? Order from Wolseley today - free delivery or click and collect available nationwide.

22 Mm Bent Tap Connector